美國VICKERS流量控制閥，伊頓威格士流量控制閥
13應用凡士林到108 mm [ 4.25英寸內徑密封，并安裝在
軸承箱的密封槽見圖。 14 。
14應用凡士林9,4毫米[ 0.37英寸內徑密封。在安裝密封
殼體泄槽軸承座。
15安裝2螺栓（早期型號） ，對角線相對的，在螺栓孔
軸承座，見圖。 15 。如果你用螺栓更換螺栓，使用2
螺柱堆放的零件時，對齊的目的。
18在輸出軸花鍵安裝驅動。對于345立方厘米/ R [ 21.0立方英寸/ R]
排量馬達驅動器插入較長的花鍵結束*，見圖。 16 。
19應用凡士林2封9,4毫米[ 0.37英寸] ID和2封
108毫米[ 4.25英寸]內徑在擺線的密封槽安裝它們，
參見圖16 ， （在擺線的兩側各密封件中的個） 。
注意：安裝在這點涉及的時序3步驟
電機。定時確定所述輸出軸的旋轉方向。
16 Install thrust washer and thrust bearing in wear plate – washer first,
see Fig. 15. A light film of lubricant on the washer and bearing will
help hold them in place.
17 Align case drain hole in wear plate with case drain hole in bearing
housing. Install wear plate flush against bearing housing, see Fig. 15.
Timing Step 1—Locate the largest open pocket in the Geroler and
mark it on the outside edge of the Geroler, See Fig. 17.
20 Align case drain hole in Geroler with case drain hole in wear-plate.
Install Geroler on wear plate, see Fig. 16. Be sure to retain rollers in
21 Install valve drive in Geroler.
22 Align case drain hole in valve plate with case drain hole in Geroler.
Install valve plate flush against Geroler, see Fig. 17.
Timing Step 2—Locate the slot opening in the valve plate which is in
line with the largest open pocket of the Geroler. See Fig. 17
 

美國VICKERS流量控制閥，伊頓威格士流量控制閥